Safety precautions for cutting machine-hydraulic tools
1, steel straightening machine should be installed on a flat solid ground.
2, the installation of the bearing frame, the center of the bearing groove to be aligned with the guide cylinder, the straightening cylinder, the lower cutter hole or the center line of the shear gear groove, and keep straight.
3, after the installation of the machine, must check whether the electrical circuit and parts are damaged, the connection of the machine is reliable, the transmission part is flexible, confirm the error before the trial operation.
4, the first empty machine operation, check the bearing (focus on examination of the straightening cylinder bearing), hammer, knife or cutting gear is working properly. Ensure that no abnormal condition, before feeding, test straightening and cutting.
safety precautions in operation
1, according to the straight bar diameter, selecting proper straightening block, traction wheel groove and the rotation speed. Straightening block diameter of large diameter than steel should be 2.5 mm, the traction wheel groove width and straightening bar diameter is the same.
2, adjust the adjustment of the straight block: the general adjustment of the cylinder has five straight block, first, the 5 must be placed on the center line, the middle of the three can deviate from the center line. First make the offset of the steel bar about 3 mm, after straightening, such as the steel bar is still bent, can gradually increase the offset until the straightening.
3, cut off the three or four steel bar to check if the length is suitable. If the length of the deviation, can adjust the limit switch or fixed board.
4, in the guide tube should be installed in the front of a 1 meters long steel pipe. By straightening steel should be first through the tube then penetrates into the guide tube and straight tube, to prevent each disc close to steel straightening after pop wounding. Stainless steel electrode
5, the straightening block is not fixed, the protective cover not cover the former does not penetrate the steel bar, in order to prevent the machine after straightening block flying away.
6, through the reinforcement, and the traction wheel hand should maintain a certain distance.
7, the steel bar in the straightening process, in order to prevent the oxidation of iron flying, pollution of the environment, should take appropriate measures to prevent dust.
YUHUAN SITUTE(SITOOT) TOOLS CO.,LTD.
Add:BinGang Industrial Zone,Yuhuan County,Taizhou City,Zhejiang Province,China
Tel:0086-576-87229709
Fax:0086-576-87296000
E-mail:sitoot@sitoot.com
sitoot@126.com
sitoot@126.com
Facebook:https://www.facebook.com/sitoot
Twitter:hhttps://twitter.com/hydraulic_tools
LinkedIn:https://www.linkedin.com/company/yuhuan-situte-sitoot-tools-co.-ltd.
LinkedIn:https://www.linkedin.com/company/yuhuan-situte-sitoot-tools-co.-ltd.
Pinterest:https://www.pinterest.com/henryy1952/
Comments
Post a Comment